Original message
| gordonp5790
 |  "Clare Megasave"
, posted Wed 27 Jul 06:15:  
I have available a re-furbished exhaust blower Model V52M053 for a HEG-80-B Megasave. I had to buy a new one while waiting for a replacement wheel. The new one cost $193.20. No reasonable offer refused. It will probably fit any model. Inlet and outlet are 3.5" o.d.
[this message was edited by gordonp5790 on Mon 1 Aug 05:23] |
| Replies:
|
| bimmer
| "Re(1):Clare Megasave" , posted Fri 7 Mar 11:45
I have a Clare Megasave furnace. Repair man says i require a restrictor plate. The furnace makes a noise when the heat comes on. To me that sounds like a motor bearing not a restrictor plate problem. He says that he cannot find the part so I would have to replace the whole furnace. Appears to be a sell job. Would that be the cause of the noise and do you know where I would be able to get one of these restrictor plates as Clare has been out of business for some time. Thanks
|
| edwardr
| "Re(1):Clare Megasave" , posted Wed 18 Oct 13:25
u still have this available ?
|
| nork
| "Re(1):Clare Megasave" , posted Sun 18 Sep 11:24
Contact me if you still have this vent motor. Does it have the special inlet shroud ? Do you still have this furnace in operation ?
Norm K
Norm K
|
| | gordonp5790
| "Re(2):Clare Megasave" , posted Sun 18 Sep 18:11:
I don't have the restrictor plate. If you'd contacted me last week I could have got it before the house was demolished. As I recall it was a stainless steel plate with a restricting orifice. Let me know if you are still interested. PS. I just looked the plate up in the ROTOM catalogue(page 13). Part #92-V52-1. Probably still available as I don't suppose there was a lot of call for it.
[this message was edited by gordonp5790 on Sun 18 Sep 18:31] |
|
|
