| Original message
|
Replies:
|
| bama 101
|  "Re(1):Nordyne error code blinks twice"
, posted Fri 12 Jan 21:09  
pressure switch open with induced draft motor on...
http://www.nordyne.com/Literature/7104890.pdf
Help is just a question away.
Safety is up to you....
....THINK........
....Safety........
|
| | jessev
| "Re(2):Nordyne error code blinks twice" , posted Sat 13 Jan 00:27
So what do I have to do to fix it?..
Thanks for your help...
|
| | bama 101
| "Re(3):Nordyne error code blinks twice" , posted Sat 13 Jan 17:20
look for the small vent motor and there will be a black or orange hose there.
Know remove hose from the end near the motor and take a piece of wire and make sure it is not stoped up at the unit end.
DO NOT BLOW COMPRESSED AIR THRU IT.........................
on the other end of this hose is a pressure switch or a safety device that can not stand no positive pressure.
DO NOT blow air thru it for no reason......
Rust sometimes stops up the hole near the motor...
Help is just a question away.
Safety is up to you....
....THINK........
....Safety........
|
| | JesseV
| "Re(4):Nordyne error code blinks twice" , posted Tue 16 Jan 10:45
Hey Bama 101 I did what you said but the error light is still on... is there anything else I can try?...thanks for your help...
|
| | tom446
| "Re(5):Nordyne error code blinks twice" , posted Wed 17 Jan 12:04
Clean drain lines and trap. Check venting for obstruction
If in doubt call a pro !
|
| | JesseV
| "Re(6):Nordyne error code blinks twice" , posted Wed 17 Jan 22:26
thanks tom446 I'll give that a try. Ill let you know if it works.
|
| | bama 101
| "Re(7):Nordyne error code blinks twice" , posted Thu 18 Jan 06:22
the blades on the draft motor could also be rusted and/or broke not allowing it to move any air.
you can remove the hose off of the pressure switch and turn the thermostat on a call for heat and let the draft motor run and put a very small piece of paper against the hose and see if it has any suction at all.
Help is just a question away.
Safety is up to you....
....THINK........
....Safety........
|
| | JesseV
| "Re(8):Nordyne error code blinks twice" , posted Sat 20 Jan 12:56
When I turn the heater on the motor does not do anything. All I hear is a click and the light starts blinking. I noticed that there was a green wire just hanging out loose close to a black wire that is in a wire nut by itself. Do you think it is supposed to be in the same wire nut?
|
|
|
"Nordyne error code blinks twice"