Original message
| danny coyle 56
 |  "Command-Air fan motors"
, posted Wed 4 Jun 12:40:  
How do you replace a Command-Air fan motor app 5ton water source heat pump. Appears to be impossible to remove motor out from housing???? Its obivios to see the squirlcage will not fit thru the opening provided for the motor. Previous units ive changed motors on have the removable ring that gets bolted on along with the motor legs and comes off when you unbolt motor. Looks like i need to remove front of duct work and try to get cage and motor thru that opening but just looking for a confo on that b-4 going thru the work of dismantling duct work just to change out a bad fan motor,,,,, Hard to think someone designed it this way !!!!! Thanks HELP
Danny Coyle
[this message was edited by danny coyle 56 on Wed 4 Jun 15:00] |
| Replies:
|
| Jojo98
| "Re(1):Command-Air fan motors" , posted Wed 4 Jun 23:15
Duke is right, Aint no way you are supposed to dismantle the duct to remove the motor. Youv'e got to be missing something, because even the craziest system engineer would build something that difficult.
|
| theduke03
| "Re(1):Command-Air fan motors" , posted Wed 4 Jun 21:13
You are making this difficult for yourself. You first un-wire and remove the whole blower assembly. Then disassemble everything.
"My dad was the most feared furnace fighter in Northern Indiana."
|
| | danny coyle 56
| "Re(2):Command-Air fan motors" , posted Thu 12 Jun 19:57
Duke,,thanks figured it out@! Had to remove duct from front of blower assembly, unscrew blower assembly and remove motor and blower from access panel, not as difficult as it appeared thanks dc
Danny Coyle
|
|
|
