Original message
| bondnj
 |  "Peerless hot water furnace problem"
, posted Wed 31 Jan 22:08  
I have a 17 year old Peerless hot water which has worked just fine for years. Recently after running for a while and close to achieving desired temperature the furnace goes out thermostat still shows it is on and the circ pump continues to run. Once I shut off and rest set system lights , heat is on and runs for a while before doing the same. I've seen threads mentioning the flame sensor which I'm happy to clean but don't know where it is located and how to access it - :'((
Anyone with any ideas? Much appreciated.
Cold in NJ
bondnj
|
|
Replies:
| |
|
|
