Original message
| jane30066
 |  "Amana GUIC HVAC Blower Problem"
, posted Sat 3 Feb 10:18  
The Anmana GUIC furance was installed about a year ago. It was running fine, but was very noisy. An out of state visitor that was familiar with furnaces opened up the unit, and somehow changed the blower settings. Now however, the unit runs but the blower is on an extremely low setting that is not acceptable for this time of year. Does anyone know how to change the blower settings? Thanks for your help.
Chilly in Georgia
|
|
Replies:
|
| yuri
|  "Re(1):Amana GUIC HVAC Blower Problem"
, posted Sat 3 Feb 11:41
Ideally you should get a serviceman in to change the blower speed AND check the temp.rise through the furnace. If it is too low the unit will cut out on limit and you will have lots of future problems. It should be serviced annually to clean the flame sensor etc.
Good Luck
Yuri
|
| | jane30066
|  "Re(2):Amana GUIC HVAC Blower Problem"
, posted Sat 3 Feb 12:39
Thanks. I will contact a HVAC service man.
Chilly in Georgia
|
|
|
