Carrier Performance 93 2 stager - http://www.hvacmechanic.com/ Forums


Original message

camman



65.92.205.190

"Carrier Performance 93 2 stager" , posted Wed 26 Sep 10:41:user profileedit/delete messagepost reply


Is this furnace or line up of these 2 stage furnaces in the good books? I don't have the Consumer Report but some experts here might know by their experience in the industry.
I would like to find out if someone could help me measure the flame sense for the correct micro amps.Can a good Volt meter be used or do you have to buy a new something?
Thanks as I learn.

[this message was edited by camman on Wed 26 Sep 10:51]

 

Replies:

justintime822

32.142.77.194

"Re(1):Carrier Performance 93 2 stager" , posted Wed 26 Sep 11:22user profileedit/delete messagepost reply


most of the time for the flame senser problem is that its just dirty, clean it with sand cloth and try it. to check micro amps you will need a meter that reads it

justintime822

 

 

camman



67.68.136.147

"Re(2):Carrier Performance 93 2 stager" , posted Wed 26 Sep 14:18:user profileedit/delete messagepost reply


I have cleaned the flame sensor. I am not sure what meter I need to check micro amps though.

[this message was edited by camman on Wed 26 Sep 14:21]

 

 

341

74.105.161.4

"Re(3):Carrier Performance 93 2 stager" , posted Wed 26 Sep 16:07user profileedit/delete messagepost reply


Look for a ľA symbol on the meter.

www.hvactechgroup.com

 

 

camman



70.55.22.48

"Re(4):Carrier Performance 93 2 stager" , posted Wed 26 Sep 20:50user profileedit/delete messagepost reply


On which points do the probes go to measure and does it matter what mode the furnace is on at the time???

 

 

jmitschke



70.113.61.44

"Re(5):Carrier Performance 93 2 stager" , posted Thu 27 Sep 07:25user profileedit/delete messagepost reply


Hey, The flame sensor only gives a reading when the burners fire and the sensor is in the flame path. Is the ceramic collar loose or cracked? That will allow the flame sensor to ground and interrupt
the signal to the control board and it will recycle 3 times . Good luck...john...austin,texas

 

 

camman



70.50.174.191

"Re(6):Carrier Performance 93 2 stager" , posted Thu 27 Sep 12:30user profileedit/delete messagepost reply


Thanks for your help. I replaced the flame sens. and now have 3.6 micro volt reading,also took burner assembly out and washed in hot soapy water and now have a smooooth ignition instead of jumpy or none at all. We shall see and wait how good this fix is.