Original message
| mlobitz
 |  "payne furnace...flame sensor??"
, posted Wed 7 Nov 17:28  
I am getting a code 34 on my Payne PG8DAA furnace. code means "Ignitor proving failure". Do I need to clean my flame sensor? Is this the round sensors (actually 2) next the flames? They don't look dirty maybe a little. I cannot get them clean with my fingers though, how dirty does this thing need to be to quit working??
|
|
Replies:
|
| smythers1968
| "Re(1):payne furnace...flame sensor??" , posted Wed 7 Nov 21:24
The flame sensor is a 1/8" rod with a single wire going to it.
Life lesson #12 Know when not to do it yourself.
WOW That Can Hurt!!
|
|
|
