Original message
| JJRRIC
 |  "heat exchangers"
, posted Wed 6 Feb 09:44:  
I have a Testo 318-v video pro inspection scope.I use it alot when checking for cracks in heat exchangers. what is the best way for checking for cracks in heat exchangers when you have either a case coil or a coil in plynum. i normally cut a small diameter hole and stick my probe in it. Is this the best and only way possible to check these and least expensive.
[this message was edited by JJRRIC on Wed 6 Feb 14:22] |
| Replies:
|
| answer
| "Re(1):heat exchangers" , posted Wed 6 Feb 21:01
how about removing or partialy removing the triangle plate on the front of the coil, this gives more horizontal access than a hole.
Be good to your fellow man not nice there is a difference.
|
|
|
