Original message
| allerickb
 |  "Thermostat upgrade Problems"
, posted Fri 8 Feb 09:01  
I recently upgraded my older GE Weathertron Thermostat to a W-R 1F95-1271 Programmable Thermostat. I matched up the wires in the most logical way I could find using the instructions leaving two of the wires from the Weathertron unused. I tested it first by trying to run just the fan only, and everything was fine. But when I tried cycled through the heating and cooling stages everything went dead. I went under the house and checked the air handled and found that a fuse above the transformer had blown, but I could still hear her transformer humming. The fuse is a Bussman GQM 32/10 and I'm having a hell of a time trying to find it. Could you please point me in the direction of where I can find this fuse, and how to correctly hook up this thermostat? I can provide pictures of how the GE was hooked up, but it has more wires than I think I would need for the W-R. The system is an original GE air handler (almost 30 years old) with resistive auxiliary heat and Goodman heat pump (about 17 years old). Your help is greatly appreciated.
Allerick B.
"Keep a little Sunshine on your face"
—Richard Pryor
|
|
Replies:
|
| | Houston204
| "Re(2):Thermostat upgrade Problems" , posted Fri 8 Feb 21:23:
Tape off your old T.
Try Radio Shack for that fuse. It appears to be GMQ
"Tip of the Day" Remember to remove power first.
[this message was edited by Houston204 on Fri 8 Feb 23:23] |
|
|
