Original message
| softerik | "Rheem heatpump Defrosting not working" , posted Sun 24 Feb 13:53:  
Hello everyone,
about defrosting not working on a Rheem classic IX heat pump
Suddenly for unknown reason the coil defrost sensor has fall apart and hit the fan, after this incident i inspect everything and everything seem to be fine except for defrosting cycle !!
Here what i did;
-i follow this similar to my prob. thread http://www.hvacmechanic.com/forums/hvacr/messages/16924.htm#0
1 Test the sensor and no ohms reading signal out of it!
2 Jumper across the 2 terminals of defrost thermostat sensor on defrost control board. No result!
3 I jumpered 2 test pin on defrost control board and defrost cycle finally start. wait for defrost and jumpered again 2 test pin, defrost cylce stop.
So, do i need a defrost sensor or defrost control board or both ??
Thanks in advance!
Erik
[this message was edited by softerik on Sun 24 Feb 15:52] | | Replies:
|
| softerik | "Re(1):Not realy helpful" , posted Mon 25 Feb 12:59  
Thanks anyway people !!
I fix my problem !
I replace another parts .
|
|
|