bryant fb4anf030 - http://www.hvacmechanic.com/ Forums


Original message

gindyhood

75.27.161.110

"bryant fb4anf030" , posted Tue 26 Feb 19:28:user profileedit/delete messagepost reply

first element comes on. second and third no go. all elements ohm at 11.2 and check for cont. is good. sequencer was cracked (and falling apart) so i replaced it. still same issue.all 3 limits check ok. in fact i switched position of limits to be for sure and still first (left) element only comes on.

thanks

[this message was edited by gindyhood on Tue 26 Feb 19:47]

 

Replies:

knightofthebass



75.37.148.147

"Re(1):bryant fb4anf030" , posted Thu 28 Feb 13:55user profileedit/delete messagepost reply

I charge $50 for a service call, which includes up to the first hour.

Cool Squad
(949)235-1095

 

gindyhood

24.123.29.145

"Re(1):bryant fb4anf030" , posted Wed 27 Feb 09:49user profileedit/delete messagepost reply

old sequencer did not have bridge. new sequencer i recieved from wilmar does have bridge.

thanks

 

theduke03

24.250.19.62

"Re(1):bryant fb4anf030" , posted Tue 26 Feb 19:48:user profileedit/delete messagepost reply

What is the model# of your Electric heat package? Are W2 and E energized with 24v from thermostat when you're checking?

You can't put a price on comfort! Be Safe.

[this message was edited by theduke03 on Tue 26 Feb 19:51]

 

 

Houston204



98.196.66.53

"Re(2):bryant fb4anf030" , posted Tue 26 Feb 22:19user profileedit/delete messagepost reply

It is possible that your old sequencer had a bridge between the low voltage connections to energize 3 strips with one signal.



You may need to jumper your low voltage connections.


"Tip of the Day" Remember to remove power first.

 

 

Houston204



98.196.66.53

"Re(3):bryant fb4anf030" , posted Tue 26 Feb 22:24user profileedit/delete messagepost reply

"Tip of the Day" Remember to remove power first.