| Original message
|
Replies:
|
| Banger
|  "Re(1):Honeywell VisionPro TH8000 - Backlight"
, posted Tue 19 Aug 16:26  
You have to change a setting in installer set-up.
Installer's Guide here:
http://customer.honeywell.com/techlit/pdf/PackedLit/69-1896EF.pdf
Follow the instructions on Pg 6 to get in installer set-up and change the value of function 280 from 1 to 0. That should turn the backlight off unless you are pressing buttons
|
| | dbieniek
| "Honeywell VisionPro TH8000 - Backlight" , posted Tue 19 Aug 16:36
How do I turn the backlight off until I need it? It currently is better than a night light.
Thanks
DBIE
|
| | Banger
| "Re(1):Honeywell VisionPro TH8000 - Backlight" , posted Wed 20 Aug 07:39
"Follow the instructions on Pg 6 to get in installer set-up and change the value of function 280 from 1 to 0. That should turn the backlight off unless you are pressing buttons"
There are only two options. Always on - low brightness, or off and the backlight always turns on to full brightness when you press buttons, should only stay on for about 8 seconds and then go off, or dim depending on your settings. If it stays on bright all the time you may have a defective t/stat.
|
|
|
