Original message
| michealrp
 |  "Concord 80, ignition issues"
, posted Fri 17 Oct 00:54  
The purge motor spins up, and I have vacuum, but the ignitor (ceramic hot surface type) won't fire up. I've got 3 blinking lights which indicate an open. I would think that I should check the voltage on the igniter but I'm not certain what it should be.
|
|
Replies:
|
| amech
| "Re(1):Concord 80, ignition issues" , posted Fri 17 Oct 19:45
120 Volts
|
| | michealrp
| "Re(2):Concord 80, ignition issues" , posted Fri 17 Oct 21:09:
I don't detect voltage on the leads from the module toward the ignitor at any point during the purge cycle or after. The purge continues and then shortly afterward, the unit shuts down and the module flashes 3 times. I'd have to look at the schematic again but as I recall that indicates an open circuit somewhere. Anything else that I can check with a multimeter that you can recommend before calling out a tech?
[this message was edited by michealrp on Fri 17 Oct 21:21] |
|
|
