Original message
| cbfuller21
 |  "Nothing working after installing thermostat"
, posted Sun 19 Oct 20:46  
I recently installed a 44155C thermostat, and I switched it over to heat (since it just got cold). However, now it appears that nothing is working. I don't know anything about my HVAC except that it's a Rheem. House is fairly new and the HVAC hasn't been changed since 2006... I suspect that something is miswired to the thermostat. Any help would be appreciated.
|
|
Replies:
|
| RobertR
| "Re(1):Nothing working after installing thermo" , posted Mon 20 Oct 18:42
We will need to know a couple of details before we can answer:
1. what is your source of heat?
a. electric heat
b. heatpump
c. fossil fuel (gas or oil)
2 what brand and model thermostat did you install?
3. can you get the indoor fan to run when you switch the fan switch from "auto" to "on"?
Let us know and we can get a better picture of the problem.
Robert R
Retired Mechanical Design Engineer that worked as an HVAC/R mechanic to pay for his education.
|
| | billsfan_ny
| "Re(2):Nothing working after installing thermo" , posted Thu 23 Oct 23:49:
I have the same problem. The heater itslef have a red light indicating 24 volts or something.
[this message was edited by billsfan_ny on Thu 23 Oct 23:50] |
|
|
