Amana air command 90 - http://www.hvacmechanic.com/ Forums
Original message
| AJR
 |  "Amana air command 90"
, posted Mon 3 Mar 10:30:  
Have just replaced the ignitor in this furnace an Amana air command 90, still having some issues, believe that flame sensor may be the cause for the previous ignitor failure, need to know how to find a part number on this piece. It is located next to the ignitor on the left side, behind the gas valve.
Revision A
I found some information, I am looking for a flame sensor part number. And would this cause a problem with the ignitor?
AJ Indiana
[this message was edited by AJR on Mon 3 Mar 10:43] |
| Replies:
|
| marchvac
| "Re(1):Amana air command 90" , posted Mon 3 Mar 13:20
The flame sensor is on the opposite side of the burner rack from the igniter. It also has one wire attached and usually only needs to be cleaned, not replaced. Clean with steel wool so you do not leave any fine grooves for carbon to accumulate or you will be cleaning it more frequently.
Be careful sometimes you don't get a second chance
|
|
|
|
