Repost about intertherm - http://www.hvacmechanic.com/ Forums
Original message
| bballjos01
 |  "Repost about intertherm"
, posted Sun 11 May 17:34  
MY pressures were.....low side 80 psi....high side 75 psi....any thoughts?
Joe.
|
|
Replies:
|
| jojo98
| "Re(1):Repost about intertherm" , posted Sun 11 May 22:11
Call in the professionals.
|
| theduke03
| "Re(1):Repost about intertherm" , posted Sun 11 May 19:40
Thye compressor must be running when you check pressures.
"My dad was the most feared furnace fighter in Northern Indiana."
|
| TnNATE1412
| "Re(1):Repost about intertherm" , posted Sun 11 May 17:59
Are you sure the gauges are calibrated to zero first?
|
| | Houston204
| "Re(2):Repost about intertherm" , posted Sun 11 May 18:54:
So if you put the low side of your gauges on your high side port it doesn't peg?
Is your compressor amp draw very low compared to unit nomenclature?
What is the suction line temp?
"Tip of the Day" Remember to remove power first.
[this message was edited by Houston204 on Sun 11 May 19:06] |
|
|
|
