Fasco Replacement? - http://www.hvacmechanic.com/ Forums

Original message

fluepipe3

12.210.133.127

"Fasco Replacement?" , posted Thu 22 May 20:58

I have a intertherm condenser with a fan motor that went out. The caps good and getting 220 voltage.
The fan motor is a GE 5kcp39cgM6885. Its 1.25AMPs,1/8HP,1075RPM,208-230volts.
Anybody know of a fasco or other replacement? Shaft down or all enclosed.
Thanks alot guys, appreciate any suggestions.

Replies:

jmshipp50

167.115.127.20

"Re(1):Fasco Replacement?" , posted Fri 23 May 10:21:

I did not find anything on that number you have listed... but I have had pretty good luck with the AO Smith "rescue" motors when I have run into these types of situations. Something like the FE6000. Based on the specs you listed, the AO Smith OYK1006 looks pretty close as well. You would just want to verify your mounting since it can vary with 48 frame motors... hope this helps!

[this message was edited by jmshipp50 on Fri 23 May 10:27]