Yuri's tech support required Eh? - http://www.hvacmechanic.com/ Forums
Original message
| theduke03
 |  "Yuri's tech support required Eh?"
, posted Sun 1 Jun 13:19  
Yuri, I've been going back and forth with a person on this forum. They have a Lennox system with an unwired stat and are trying to figure out how to re-wire it. I am getting more confused as I read each reply they post and even a fancy Houston diagram was not enough to solve this. Perhaps if you have a minute you could chime in on the post below from whitepine?
"My dad was the most feared furnace fighter in Northern Indiana."
|
|
Replies:
|
| yuri
| "Re(1):Yuri's tech support required Eh?" , posted Sun 1 Jun 15:39
Unfortunately I don't know too much about heat pump wiring as we don't have many where I live (too damn cold). I do know that enerstats, the ones I saw 25 yrs ago are obselete and were absolute garbage. I would recommend the poster call a Lennox tech who knows heat pumps and have a good Honeywell VisionPro installed. Sorry I can't be more help.
Yuri
|
|
|
|
