28,000 BTU window unit - http://www.hvacmechanic.com/ Forums
Original message
| David Hendley
|  "28,000 BTU window unit"
, posted Mon 21 Jul 12:00:  
It is a 240 v. unit. I had to repair a hole I the condensor. I need to put power on the unit so I can charge the unit. but the cord was taken off because they thought it could not be fixed.
I have messed up and put my reply in the wrong place. This is my first time and it was a stupid move. but if you can help it would be greatly appericated.
Thamks
David H.
[this message was edited by David Hendley on Mon 21 Jul 15:38] |
| Replies:
|
| Freon
| "Re(1):28,000 BTU window unit" , posted Mon 21 Jul 14:38
Since there is no information to go on, you will have to hope you can see where the original power chord connected. Hopefully there is a hole through which the chord went. Open the unit and look for signs of cut wires. There should be three... green (ground), white (neutral) and black(hot). I am assuming a 120 volt unit. Be careful... without the wiring diagram (and you can't get that without make/model) you're only doing an educated guess at best.
Why was the power chord removed in the first place? Maybe the unit was dead and you're wasting your time. Just a thought
|
| Freon
| "Re(1):28,000 BTU window unit" , posted Mon 21 Jul 14:35:
[this message was edited by Freon on Mon 21 Jul 14:39] |
|
|
|  |
|
