Trane Home Comfort Sensor - not functioning - http://www.hvacmechanic.com/ Forums
Original message
| HomeOwner133
 |  "Trane Home Comfort Sensor - not functioning"
, posted Sat 30 Aug 22:30  
I disconnected a Trane Home Comfort Sensor (ZUSTATALP510) from the wall to install some new drywall. This involved disconnecting four wires from the back of the unit. After installing the new drywall, I reconnected the wires exactly as they were and plugged the six pins of the circuit card back into the unit. However, after plugging in the pins, the display on the Sensor remained blank, as if it were turned off. The green light in the bottom right hand corner of the Sensor is off. How do you restart, or turn on the Sensor after it has been disconnected from the wiring?
HomeOwner
|
|
Replies:
|
| oldmangobles
| "Re(1):Trane Home Comfort Sensor - not functio" , posted Sun 31 Aug 09:27
was the power shut off to the t-stat,before,during and after the work was done?usually you need to reset the 120 volt power to the t-stat.
old man mike
|
| | Homeowner133
| "Re(2):Trane Home Comfort Sensor - not functio" , posted Tue 2 Sep 11:30
Its 240 volt, but how do you reset the power?
HomeOwner
|
|
|
|  |
|
