Payne PH3P w/ Honeywell T8611R - http://www.hvacmechanic.com/ Forums
Original message
| wcurtis
 |  "Payne PH3P w/ Honeywell T8611R"
, posted Mon 6 Oct 18:32  
I need help connecting the two. Installed Heat Pump over weekend including 10kW Heat. Unit had 6 control wires to connect to subbase as follows (Unit-Subbase)
B-C
O-O
R-R
G-G
Y-Y
W-E jumpered to W2
Now I start to get confused. 10Kw Heater has three wires to be connected: Common (B) and one for each set of strips (W and V).
I assume the B's go together, and the W's too, but what about the V?
Now, on to my Honeywell T8611R, it has:
R
C/X
L
W2
E
W1 jumpered w/ Y1
G
O
B
P
I assume I can ingnore the L (monintor) and the P (defrost) as they were not connected before.
With all that said, here is what I think is correct and what I need help with: (unit w/10Kw - Honeywell subbase)
B-C/X
O-O
R-R
G-G
Y-Y1
W-W2
V-E
Any help would be appreciated.
Bill
|
|
Replies:
| |
|
|
|
