It tries!! - http://www.hvacmechanic.com/ Forums
Original message
| squidman72
|  "It tries!!"
, posted Wed 15 Oct 09:55  
I have a Model Ruud 90 plus. The ignitor comes on and it lights the burner but the burner only stays on for 3 seconds then it shuts off. Is there a flame sensor that is bad or what is going on here?
|
|
Replies:
|
| tinner73
|  "Re(1):It tries!!"
, posted Wed 15 Oct 16:51
clean the flame sensor in the far left burner.
union trained in Chicago
|
| | squidman72
| "Re(2):It tries!!" , posted Thu 16 Oct 21:09
Thanks for the info on the flame sensor. I did that and it still did not work. It ended up being moisture in the connector for the flame sensor. cleaned it and dried it-nothing. I cut the wire out of both sides of the connector and wire nutted them together and that worked.
|
|
|
|
