Indicer Motor Running Constantly - http://www.hvacmechanic.com/ Forums
Original message
| dpmarkey
 |  "Indicer Motor Running Constantly"
, posted Sat 25 Oct 15:44  
Hell,
I have a Bryant 383KAV060135 and the indicer motor is running constantly. I even disconnected the thermostat wires from the board and it still runs. I just replaced the board about 1-2 years ago due to a differnt problem... from what I have been reading, it could be a bad board. Any ideas?
-Dean
|
|
Replies:
|
| yuri
| "Re(1):Indicer Motor Running Constantly" , posted Sat 25 Oct 16:26
Sounds like it is the board. Was it a new board that you installed 2 yrs ago? There should be some small Zettler relays on the board. Try tapping them gently and if it stops then you have the culprit. They usually stick off when they get old. Had any power surges lately?
Yuri
|
| | dpmarkey
| "Re(2):Indicer Motor Running Constantly" , posted Sun 26 Oct 01:44
It was a brand new board that I installed. I tried tapping on the relays and nothing happened. I haven't had any power surges that I am aware of.
-Dean
|
|
|
|
