Commercial Freezer Contacts question

General topics about all things heating, ventilation, air conditioning and refrigeration.

Commercial Freezer Contacts question

Postby DQJim » Fri Sep 23, 2011 5:57 pm

Cross posted this in Commercial

I have a commercial freezer that is not kicking on. When opening the cabinet, I found a fan that had come off the shaft and had wedged into the motor. I re-installed the fan. The unit still did not respond. I checked capacitors and found one bad, replaced. Still no kick on. When power is applied, 240, slight tick from defrost control board. when I manually push in contacts, compressor and fans kick on. I checked voltage going to contact solenoid and it had voltage, 22vac. Ohms were 1.757 disconnected. I am guessing that the solenoid is bad on contacts. How did I do? Contact is Furnas 45CG20AG. Thanks guys
DQJim
Minimal
 
Posts: 2
Joined: Fri Sep 23, 2011 5:33 pm

- Commercial Freezer Contacts question

Postby SAMCRO » Sun Sep 25, 2011 1:41 pm

Good,just be sure that the control voltage to the contactor is supposed to be 24vac and not 110vac./240vac.

you can tell by reading the coil voltage on the existing contactor...


hope this helps...keep up the good work!
SAMCRO
Minimal
 
Posts: 1
Joined: Wed Aug 17, 2011 7:50 pm

- Commercial Freezer Contacts question

Postby heatseeker » Mon Sep 26, 2011 8:20 am

good luck with that let us know what happens.
heatseeker
Most Valued Contributor
 
Posts: 542
Joined: Wed Jul 06, 2011 9:10 am

- Commercial Freezer Contacts question

Postby westcanadian01 » Wed Sep 28, 2011 12:59 am

Would agree to Samcro's reminder.
Also always be careful.Great job!
westcanadian01
Most Valued Contributor
 
Posts: 40
Joined: Sat Jul 16, 2011 12:43 am


Return to HVAC General Forum

cron