RUUD URGG 10E36JKR

Problems related to residential installations.

Moderator: juster

Post Reply
lleonard3
Minimal
Posts: 2
Joined: Mon Jan 30, 2012 5:31 pm

RUUD URGG 10E36JKR

Post by lleonard3 » Mon Jan 30, 2012 5:35 pm

Looking for wiring diagram for this unit.
The one inside the panel is gone
Want to change blower speeds
Any help will be appreciated
Local distributors say they don have one ?

heatseeker
Most Valued Contributor
Posts: 542
Joined: Wed Jul 06, 2011 9:10 am

- RUUD URGG 10E36JKR

Post by heatseeker » Tue Jan 31, 2012 12:23 pm

Generally *
*=* *= med low but results may vary.

lleonard3
Minimal
Posts: 2
Joined: Mon Jan 30, 2012 5:31 pm

- RUUD URGG 10E36JKR

Post by lleonard3 » Tue Jan 31, 2012 10:59 pm

Thanks for the reply
The problem I have here is there is two run capacitors in system. One is a 3.5 and the other is 7.5 mfs.
I dont know which one is for low or high. And which wires I change in the panel.There is two wires capped off.
Im a little reluctant to just start switching wires and frying a relay or the board

Mr Bill
Regular Contributor
Posts: 18
Joined: Mon Dec 19, 2011 10:35 am

- RUUD URGG 10E36JKR

Post by Mr Bill » Tue Jan 31, 2012 11:40 pm

That is an "old" self contained 3-ton package unit, one cap is for the blower motor and one is for the condenser motor. I am actually a Ruud dealer, my guess/gut is the 3.5 is for the condenser motor, but just follow the wires from the cap and they will lead you to whatever motor the cap is related to. I bet that unit if it still has the original blower motor, it was probably only a two speed, one for cooling and one for heating, usually black for high and red for low.

Post Reply