Frigadaire furnace on LP model 80-90

[bretty1110]

I have this furnace, i had some trouble already found that it needed a stage 2 reg, so thats in ,it goes threw the stages but when the furnace turns on , and the flame starts , the fan is blowing while its heating up the plemium ,its gets warm but not as hot as it should , i knw the blower is on low , somewhere or set to something , how do you reset or change the timer ? all i see are a set of jumpers ? or is this normal ?, i have a dim yellow light on the board meaning a ground , i was told i have to ground out the board or check my grounds ,i have no clue

[Silverjwj]

I would get somebody to fix it who does have a clue!

[how]

What made you think that the 2 stage valve was the problem? Was it getting 24V on the upper stage before and not opening up?
That upper stage is controled by a timed board dip switch or by a compatable thermostat so you could have a board or thermostat problem.
The ground advise is unclear as the board should already be grounded but all modern furnace electronics depend on solid grounding to function. Check that your ground connections from the board all the way back to the house breaker are good.

A pro might cost but hopefully not in un nessesary parts.