Hunter 44260 Thermostat Install Questions

Problems related to residential installations.

Hunter 44260 Thermostat Install Questions

Postby gringgo » Sat Apr 30, 2011 12:45 pm

I am replacing a very old dial type thermostat with a Hunter 44620 Heat Pump thermostat. Link to 44620 manual...*-*://-.hardwarestore.com/media/pdf-misc/603274.**-*. Here is a link to the Carrier model the t-stat is for...*-*://-.xpedio.carrier.com/idc/groups/public/documents/techlit/50yx-2pd.**-*. It is called a Single-Package Heat Pump.

I have 5 wires coming out of the wall, but only 4 are used.

Blue ----> O
Green --> G
Red -----> Rc
Yellow -> Y
White --> Not Used

Jumper from Rc to Rh
Jumper from W to Y
A White wire on the old t-stat's board goes to Y

I am ok with Green (G) and Red (Rc), but Blue (O) and Yellow (Y) go to the same place. This does not seem correct since the manual has an OR condition for O and Y. Also, should I jump W and Y?

Any and all assistance is greatly appreciated. Thank you in advance.

John
gringgo
Minimal
 
Posts: 2
Joined: Sat Apr 30, 2011 11:55 am

- Hunter 44260 Thermostat Install Questions

Postby gringgo » Sat Apr 30, 2011 4:38 pm

*-*://i1206.photobucket.com/albums/bb445/hvactechfw/sshphunterstat2.*/-*

Thanks to hvactechfw for the diagram.
gringgo
Minimal
 
Posts: 2
Joined: Sat Apr 30, 2011 11:55 am

- Hunter 44260 Thermostat Install Questions

Postby aircooledtx » Sun May 01, 2011 6:26 am

**"gringgo"-**-*://i1206.photobucket.com/albums/bb445/hvactechfw/sshphunterstat2.*/-*

Thanks to hvactechfw for the diagram.*/-*



Red- 24volt rc-rh

Green- fan curcuit- G

Blue- O-reverse valve -heat pump

Yellow- y-cooling
aircooledtx
Most Valued Contributor
 
Posts: 46
Joined: Wed Apr 27, 2011 12:18 pm


Return to Residential