I have a Carrier Tech2000 heat-pump for my basement. Air handler is a model FK4BNFoo3oooAAA. Control board CESO130007-00, variable speed ECM controlled 1/2hp 220v motor model 5SME39HL0058. Manufacture date was in 1994. The house was built in the mid 70's so this was an add on unit.
When the thermostat is in AC the blower in the air handler will not cycle off, I've disconnected the G wire at the circuit board and it still runs. when I switch to off on the thermostat the fan shuts off after several minutes. The system cycles normally in heat mode.
This problem has been around for I know several years, may have been that way when I bought the house 6 years ago. I rarely need AC downstairs as half of the room is underground. I've finally decided to try and take care of it but this whole ECM thing has me and my HVAC buddies a bit puzzled. Since there are no relays on the control board (which was where my online trouble-shooting was going) is the problem in the ECM module on the back of the * I don't see any relays there either. Can it be repaired on a component * (I know how to solder) or do I need to replace the whole *
I also have not been able to cross my air-handler model # over exactly, one number or one letter off. Hope it's not some odd-ball with no replacement parts.
Your help will be much appreciated!!
Thanks for reading this.