Janitrol to Hunter 44905

[cookedj]

Hi, I'm having a bit of an issue. My Heat pump is a Janitrol PH030-1a, the thermostat was a Hunter 44860, and there were only a few wires marked. Could someone help with the unmarked *

RC/R Red
Y1 Yellow
C Blue
E Brown
Orange
Green
White

The white one is the one I'm not sure about. Thanks
Derek

[Freon]

O should go to the O terminal. That's the reversing valve and assumes when you are using the AC, the reversing valve needs to be powered.
G to the G terminal... that's the blower
White from the W2 of the thermostat (Aux heat) to the W1 of the Janitrol.

All of these suggestions are based on this - - dot acdirect dot com/xcart/images/products/IO-313.pdf Table 3 Page 6
hunter-thermostats dot com/booklet/44860.pdf page 11

Make sure all power is off when playing with wires, even low voltage