I just ordered a replacement siingle pole contactor for my old Carrier central AC but it arrived with a slightly different setup (it came with an extra pole which I'm just ignoring and the side coil contacts (at least I'm calling them that) are now on separate sides )
the problem is not with the main pole wiring (2 wires/connectors on one end, 2 w/c on the other; which I'll just duplicate at re-install)...let's say those 2 are NORTH and SOUTH
now the problem/difference: the original had on one side 2 connectors (with yellow wires attached which came out of the coil on the bottom)(let's call this side EAST), the new one has only one connector on that side and a connector on the other side now (WEST) ... both still connected to the coil on the bottom
is there a way I couild damage this by wiring these 2 coil ends *
I'll send photos if you'd like
tomf Reno
thanks in advance for any help