> First, suspect the inducer motor/assembly. If it's locked or semi-shorted
> it will draw enough current to give you the low voltage readings.
> Simple test of the gas valve involvement... mark the wires and then
> disconnect them from the valve. Does the inducer run? If not, pull the
> inducer and inspect the motor.
Thanks for the response
No it does not run, I get the call for heat from the Therm. but it has no fire to the motor from there obviously leading to no ignition for the burners.
I am getting my readings for voltage straight from the board, would that make any difference? I am only pulling MAX 7.8VAC from the inducer connections straight from there.