Can the exhaust blower motors be oiled ?

General topics about all things heating, ventilation, air conditioning and refrigeration.

Can the exhaust blower motors be oiled ?

Postby engineoops » Tue Feb 12, 2013 12:40 pm

Have a bryant 383kav036070 fornace.Can the little square exhaust blower be oiled ?Was it made to be oiled ?Thank you
engineoops
Minimal
 
Posts: 1
Joined: Tue Feb 12, 2013 12:35 pm

- Can the exhaust blower motors be oiled *

Postby Freon » Tue Feb 12, 2013 3:38 pm

Most likely the motor bearings are sealed and can not be lubricated. If you fins small, one eighth inch holes at the bearing location then try using 2 drops of light oil. If no oil holes, to buy some time you may try and run light weight oil down the shaft into the front bearing. Sometimes it can seep in, depending on the bearing. Spin the shaft as the oil runs down.

If you can remove the motor you may find it less expensive to get new bearings from an electric motor shop. Compare new bearings to the cost of a new motor to be sure it's worth the time and effort.
Freon
Most Valued Contributor
 
Posts: 715
Joined: Sat Jun 18, 2011 11:26 am


Return to HVAC General Forum

cron